A practical reference on Deamidation: what it is, how it behaves, what the literature reports, and where the honest uncertainties sit.
This page was last updated on 2025-09-15 and is reviewed periodically as new material appears.
Laboratory handling begins with dissolution of the lyophilized powder in water or a suitable aqueous buffer. The dry solid is the more stable form, so stock solutions are generally prepared only when required and kept cold afterwards. Repeated freezing and thawing of a solution is avoided because it encourages aggregation and gradual loss of the intact chain. Diluents and containers are selected to limit adsorption of a short peptide onto plastic surfaces and to reduce microbial growth in aqueous preparations.
Stability depends strongly on pH, temperature and the presence of oxygen and trace metals. Cleavage of the backbone proceeds faster under neutral to alkaline conditions, whereas acidic solutions tend to slow that reaction. The aspartate and glutamate side chains can undergo deamidation or imide formation over time, generating closely related impurities. Published stability data specific to epitalon are sparse, so the usable life of a given solution is best regarded as an open question that depends on buffer composition, concentration and storage temperature.
Freeze-dried epitalon is normally kept at minus twenty degrees Celsius in a sealed, desiccated container, protected from light. Short excursions at ambient temperature during shipping are generally tolerated, but repeated warming and cooling cycles encourage moisture uptake, which shortens shelf life. Once dissolved, the peptide is far less stable than the solid: aqueous solutions are subject to hydrolysis and to deamidation at the aspartate and glutamate residues. Working solutions are therefore held refrigerated and used within days, and repeated freezing and thawing of the same vial is best avoided.
Identity and purity are checked by reversed-phase high-performance liquid chromatography, usually with ultraviolet detection near 214 nanometres, where the peptide bond absorbs. Mass spectrometry confirms the expected mass and reveals whether truncation products or adducts are present. Acid hydrolysis followed by amino acid analysis gives the residue ratio, which should approximate one alanine, one glutamate, one aspartate and one glycine. Counter-ions such as acetate or trifluoroacetate remain in the dried product and lower net peptide content, so a stated purity figure on a label does not by itself describe how much peptide a vial holds.
Regulatory treatment differs by country. No formulation of epitalon holds a marketing authorisation as a medicine in the United States or the European Union, where material sold for laboratory use is handled as a research chemical and is not intended for human consumption. In Russia, several short peptide preparations from the same institute's peptide series are registered medicinal products, and epitalon appears in that national context. Elsewhere it is frequently offered as a cosmetic ingredient, a category with lighter requirements. Advertising claims about longevity or disease prevention are restricted in most jurisdictions, which limits how sellers describe the compound.
| Property | Value | Notes |
|---|---|---|
| Storage temperature, dry powder | -20 degrees Celsius or lower | Sealed, dark, low humidity |
| Storage temperature, solution | 2 to 8 degrees Celsius | Short-term use expected |
| Primary purity method | Reversed-phase HPLC | Ultraviolet detection near 214 nm |
| Identity confirmation | Electrospray mass spectrometry | Compared with calculated mass |
| Typical purity specification | Area percent of 95 or higher | Depends on column and gradient |
Peptides of this size are generally stable as dry solids but degrade in solution over time. The principal routes are hydrolysis of the peptide backbone and oxidation, with hydrolysis favoured by elevated temperature and extreme pH. Aqueous solutions held at room temperature can show measurable loss of purity within days, while frozen aliquots are considerably more durable. Because the sequence contains neither cysteine nor methionine, oxidation is less of a concern than for many other peptides, but pH control during handling still matters.
Typical storage for the lyophilized powder is −20 °C or lower, in a sealed container protected from light and moisture. Hygroscopic material should be allowed to equilibrate to room temperature before the vial is opened, which limits condensation on the contents. Working solutions are commonly divided into single-use aliquots and frozen to avoid repeated freeze-thaw cycles. Dilute solutions are more prone to adsorption onto plastic surfaces and to loss during filtration, so procedures that minimize transfers and use low-binding labware are preferable.
Chemical antagonism occurs when a chemical antagonist combines with a ligand to form an inactive product compound, inhibiting the response. In chemical antagonism, the receptors are not involved in the process, and the antagonist directly binds with or removes the ligand. It prevents the ligand from binding to the receptor. As the ligand cannot stimulate the receptor, no physiological effect is generated by the receptors and thus provides an inhibitory effect. The common types of chemical antagonism include chelating agents, neutralising antibodies and salt aggregation.
An investigational device exemption (IDE) allows an investigational device (i.e. a device that is the subject of a clinical study) to be used in order to collect safety and effectiveness data required to support a premarket approval (PMA) application or a premarket notification [510(k)] submission to Food and Drug Administration (FDA). Clinical studies are most often conducted to support a PMA. Only a small percentage of 510(k)'s require clinical data to support the application. Investigational use also includes clinical evaluation of certain modifications or new intended uses of legally marketed devices. All clinical evaluations of investigational devices, unless exempt, must have an approved IDE before the study is initiated. Clinical evaluation of devices that have not been cleared for marketing requires:
ALK-positive ALCL is diagnosed by histological and immunological examinations of involved tissues, typically lymph nodes. These tissues have lymphoma-like infiltrates that have variable numbers of ALCL "hallmark" cells, i.e. cells with kidney- or horseshoe-shaped nuclei that strongly express CD30 as detected by immunohistochemistry and an ALK fusion protein as detected by fluorescence in situ hybridization. These cells are scattered throughout the infiltrates. WHO classifies these infiltrates into 5 patterns: a common pattern consisting of large variably shaped cells with large nuclei that typically contain multiple nucleoli (60–70% of cases); a small-cell pattern consisting of small to medium-sized neoplastic cells with clear cytoplasm and "hallmark" cells that are concentrated around small blood vessels (5–10% of cases); a lymphohistiocytic pattern consisting of small neoplastic cells along with abundant histiocytes (10% of cases); a Hodgkin's-like pattern in which the architecture resembles the nodular sclerosis pattern of Hodgkin lymphoma (3% of cases); and a composite pattern consisting of two or more of the just described patterns (15% of cases). Detection of circulating autoantibody against ALK supports the diagnosis. Individuals with low levels of these autoantibodies are at an increase risk of relapsing after treatment.
Sources: en.wikipedia.org
Integrator complex subunit 15, also known as C7orf26, is a protein encoded in humans by the INTS15 gene. Based on properties of c7orf26 and its conservation over a long period of time, its suggested function is targeted for the cytoplasm and it is predicted to play a role in regulating transcription. Chromosome 7 is one of the 23 pairs of chromosomes in the human body, and spans about 159 million base pairs and represents about 5-5.5% of the total DNA in cells. Changes to the structure of chromosome 7 can result in a number of genetic abnormalities, including Williams Syndrome which causes structural and cosmetic changes to the human body, ultimately resulting in a shorter lifespan. There are hundreds of known open reading frames (ORF) along the domain of chromosome 7, however there is not much known about the 26th reading frame, which is of considerable interest. Currently, two isoforms of c7orf26 are known in Homo Sapiens and are referred to as isoforms 1 and 2, respectively.
The American Society for Biochemistry and Molecular Biology (ASBMB) is a learned society that was founded on December 26, 1906, at a meeting organized by John Jacob Abel (Johns Hopkins University). The roots of the society were in the American Physiological Society, which had been formed some 20 years earlier. ASBMB is the US member of the International Union of Biochemistry and Molecular Biology. The ASBMB was originally called the American Society of Biological Chemists, before obtaining its current name in 1987. The society is based in Rockville, Maryland. ASBMB's mission is to advance the science of biochemistry and molecular biology through publication of scientific and educational journals, the organization of scientific meetings, advocacy for funding of basic research and education, support of science education at all levels, and by promoting the diversity of individuals entering the scientific workforce. The organization currently has over 12,000 members.
AAA proteins are divided into seven basic clades, based on secondary structure elements included within or near the core AAA fold: clamp loader, initiator, classic, superfamily III helicase, HCLR, H2-insert, and PS-II insert. AAA ATPases assemble into oligomeric assemblies (often homo-hexamers) that form a ring-shaped structure with a central pore. These proteins produce a molecular motor that couples ATP binding and hydrolysis to changes in conformational states that can be propagated through the assembly in order to act upon a target substrate, either translocating or remodelling the substrate. The central pore may be involved in substrate processing. In the hexameric configuration, the ATP-binding site is positioned at the interface between the subunits. Upon ATP binding and hydrolysis, AAA enzymes undergo conformational changes in the AAA-domains as well as in the N-domains. These motions can be transmitted to substrate protein.
Some MAAs protect cells from reactive oxygen species (i.e. singlet oxygen, superoxide anions, hydroperoxyl radicals, and hydroxyl radicals). Reactive oxygen species can be created during photosynthesis; further supporting the idea that MAAs provide protection from UV light. Mycosporine-glycine is a MAA that provides antioxidant protection even before Oxidative stress response genes and antioxidant enzymes are induced. MAA-glycine (mycosporine-glycine) is able to quench singlet oxygen and hydroxyl radicals very quickly and efficiently. Some oceanic microbial ecosystems are exposed to high concentrations of oxygen and intense light; these conditions are likely to generate high levels of reactive oxygen species. In these ecosystems, MAA-rich cyanobacteria may be providing antioxidant activity.
Sources: en.wikipedia.org
To address specific nutritional needs of individual patients, several providers of IDPN therapy developed formulations that take clinical variables into account in order to best fit the patient's individual needs and condition. Specific formulations address distinct differences between nutritional needs of those patients who exhibit protein malnutrition and those patients who exhibit calorie malnutrition. Nutrition Clinical nutrition
Color markers are sometimes added to loading dyes for gel electrophoresis in the separation of DNA fragments. Loading dyes keep DNA samples below the surface of the agarose gel, and the color markers within help keep track of the migration front of the DNA as it moves along the gel. For PAGE, some commercially available molecular weight markers (also called "ladders" because they look like the rungs of a ladder after separation) contain pre-stained proteins of different colours, so it is possible to determine more accurately where the proteins of interest in the samples might be.
The main building of the Institute is located at the intersection of Kremlyovskaya and Lobachevskaya streets. This four-story building built in 1953 in the style of Soviet neoclassicism under the guidance of architect A.G. Bikchentaev. The building of the museum of Kazan chemical school is located in the campus of the main university building, built in the 1830s in a classical style under the guidance of architect M.P. Corinfskiy. In 2015 construction of a large laboratory building in the campus of Alexander Butlerov Institute of Chemistry was finished. The 7-storey building housed classrooms and laboratories of departments of Alexander Butlerov Institute of Chemistry, Institute of Geology and Petroleum Technologies, Institute of Physics. The building was constructed with the support of the President of Tatarstan R.N. Minnikhanov and PSC "TAIF".
To annotate the vast amounts of available NGS data, currently a large number of SNPs annotation tools are available. Some of them are specific to specific SNPs while others are more general. Some of the available SNPs annotation tools are as follows SNPeff, Ensembl Variant Effect Predictor (VEP), ANNOVAR, FATHMM, PhD-SNP, PolyPhen-2, SuSPect, F-SNP, AnnTools, SeattleSeq, SNPit, SCAN, Snap, SNPs&GO, LS-SNP, Snat, TREAT, TRAMS, Maviant, MutationTaster, SNPdat, Snpranker, NGS – SNP, SVA, VARIANT, SIFT, LIST-S2, PhD-SNP and FAST-SNP. The functions and approaches used in SNPs annotation tools are listed below. Variant annotation tools use machine learning algorithms to predict variant annotations. Different annotation tools use different algorithms. Common algorithms include: Interval/Random forest-eg.MutPred, SNPeff Neural networks-eg.SNAP Support Vector Machines-e.g. PhD-SNP, SNPs&GO Bayesian classification-eg.PolyPhen-2
PHLPP is a member of the PPM family of phosphatases, which requires magnesium or manganese for their activity and are insensitive to most common phosphatase inhibitors, including [okadaic acid]. PHLPP1 and PHLPP2 have a similar domain structure, which includes a putative Ras association domain, a pleckstrin homology domain, a series of leucine-rich repeats, a PP2C phosphatase domain, and a C-terminal PDZ ligand. PHLPP1 has two splice variants, PHLPP1α and PHLPP1β, of which PHLPP1β is larger by approximately 1.5 kilobase pairs. PHLPP1α, which was the first PHLPP isoform to be characterized, lacks the N-terminal portion of the protein, including the Ras association domain. PHLPP's domain structure influences its ability to dephosphorylate its substrates. A PHLPP construct lacking the PH domain is unable to decrease PKC phosphorylation, while PHLPP lacking the PDZ ligand is unable to decrease Akt phosphorylation.
Sources: en.wikipedia.org
The dry powder is typically held at -20 degrees Celsius or lower, protected from light and moisture. Allowing a sealed vial to reach room temperature before opening reduces condensation on its contents. Conditions stated on a supplier certificate of analysis take precedence over general guidance.
Mass spectrometry supplies an observed molecular mass that is compared with the calculated value for the tetrapeptide. Reversed-phase chromatography then separates the main peak from related impurities. Neither technique alone establishes residue order, so sequence-level confirmation may call for tandem mass spectrometry or amino acid analysis.
No single published figure applies, because stability depends on pH, concentration, temperature and sterility. Cold storage slows hydrolysis without halting it, and microbial growth is a separate concern in non-sterile solutions. Most laboratories rely on their own analytical checks rather than a fixed expiry period.
The solid is kept cold, dry and dark, typically at minus twenty degrees Celsius, in a sealed container with desiccant. Dissolved material is kept refrigerated and used promptly. Freezing and thawing a solution repeatedly is avoided because it accelerates degradation.